Centrifugal Pump (S Type)

New type power-saving horizontal type pump

Ransport clear water

To meet the requirement of the customer, through changing the structure of the pump, it can be used to transport the corrosive liquid applicable to supply and drain water for factory, mine when repair and examination, there is no need to disassemble theinlet, outlet pipe and the motor can adjust the axial position

Using grease lubrication
Can be drove by gas engine
Brief introduction of the pump

S type uniterminal balanced suction centrifugal pump is a new type power-saving horizontal type pump, which is used to transport clear water or other liquid that has the similar chemical and physical property with the water. To meet the requirement of the customer, through changing the structure and material of the pump, it can be used to transport the water containing bedload and other corrosive liquid. This series of pump is applicable to supply and drain water for factory, mine and city, and all kinds of water conservancy projects such as electricity station and farmland irrigation.

The instruction of the structure:

The inlet and outlet of this type of pumps are below the axial lead of the water pump and are vertical with the axis line. When repair and examination, there is no need to disassemble the inlet, outlet pipe and the motor. Seeing from the direction of driving, the pump is circumrotating clockwise. We can change it into counter-clockwise.

The main components of the pump are: Pump body, pump cover, impeller, axis, balanced suction seal loop, axial bush, and etc.

The pump body and pump cover consists of the working room of the impeller. On the water inlet flange and outlet flange. There is pipe tap for installing the vacuum meter and pressure meter. Under the inlet flange and outlet flange, there is pipe tap for pouring the water.

The impeller after quiet balance checkout is fixed on the axis by axial bush and the axial bush nuts on the both sides. Axile nuts can adjust the axial position.

The pump axis is supported by two single low annular ball bearings. The bearing is in the bearing body, installed on the two ends of the pump body. Lubricate it by butter. Balanced suction seal loop is used to reduce the water in pressure room of water pump leak to water jet room.

The pump is directly driving by flexible shaft coupling. It also can be drove by gas engine.

The axis seal is flexible sealant (We can adopt mechanical seal structure).

More Product Features